HDEAR Posted October 9, 2023 Share Posted October 9, 2023 (edited) Hi all, Weird question I know, but is it possible to have the closed type bend relief values show in the parameter table? In this example below, Top=1.5mm, Bottom = 1.5mm. At present it doesn't seem possible. Many thanks, Harley Edited October 9, 2023 by HDEAR Quote Link to comment Share on other sites More sharing options...
HDEAR Posted October 13, 2023 Author Share Posted October 13, 2023 Bump! Quote Link to comment Share on other sites More sharing options...
Bertrand Kim Posted October 13, 2023 Share Posted October 13, 2023 hI HARLEY! What exactly do you mean the closed type bend relief? Kim Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted October 13, 2023 Share Posted October 13, 2023 (edited) Hi Harley, I've tried to demonstrate how to control Bend Corner Reliefs via Parameters in the attached video. It's important to add the Parameter(s) first at the Feature (Bend) Level. Then you can reference that Parameter Name in the Bend Properties. Malcolm Sheet Metal Bend Corner Relief Parameters.mp4 Sheet Metal Bend Corner Relief Parameters.ics Edited October 13, 2023 by Malcolm Crowe Quote Link to comment Share on other sites More sharing options...
HDEAR Posted October 17, 2023 Author Share Posted October 17, 2023 Perfect - thanks Malcolm. Quote Link to comment Share on other sites More sharing options...
HDEAR Posted October 17, 2023 Author Share Posted October 17, 2023 On 10/13/2023 at 5:23 PM, Bertrand Kim said: What exactly do you mean the closed type bend relief? Sorry Kim, unclear English syntax. I meant the bend corner reliefs that are the type that you would normally use to create closed corners and suchlike. Harley Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.