Handle problem

[arfa]

Hello ironcad community,

I am still new in this ironcad software , before that i am sorry for my english.

i need help to know how to fix this handle of assemblies because not aligning with my assemblies.

i attached picture below 

thanks.

[Bertrand Kim]

Hi arfa,

Is that a parametric model?

I had a same experience, the easiest fix is to rotate the object 180 degrees affected of the sizebox.

 

If your model is not a parametric model, try Regenerate tool.

 

Kim

Edited May 26, 2023 by Bertrand Kim

[ASPEER]

Another cause may be that the assembly is offset from the sizebox, unfortunately in my experience this requires a larger fix than the methods Kim put forward, so try those first. If this only happened on this assembly, I would delete and pull another out from the catalog if it is stored. Only after I determine that it is a model issue do I properly debug the model.

[Bertrand Kim]

Oh, I forgot there was Reset Sizebox in Tools of Ribbon bar. Try this tool also. 

 

Kim

[arfa]

On 5/26/2023 at 10:43 AM, Bertrand Kim said:

Hi arfa,

Is that a parametric model?

I had a same experience, the easiest fix is to rotate the object 180 degrees affected of the sizebox.

 

If your model is not a parametric model, try Regenerate tool.

 

Kim

Hi Kim,

thanks for reply and sorry for late reply ,

I did as you said and its worked now ,

thank you so much for helping me

[arfa]

Hi @ASPEER,

thanks for reply , I have done what kim told me to do and its worked,

but thank you for providing a solution that will help me in the future.