cadimonium Posted April 27, 2023 Share Posted April 27, 2023 I'm trying to use the project feature onto a sketch of a building layout, and when I attempt to extrude my projection, I get an error message stating the projection is not a solid part. The projections are simple shapes with no gaps or overlaps, so I'm not sure how to fix the error. Any tips or suggestions? Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted April 27, 2023 Share Posted April 27, 2023 (edited) Within the sketch, check the corners where the various lines meet. They need to be "Connected", which is indicated by a white dot. If any of these aren't white, right-click on the connection and select "Connect". Malcolm Edited April 28, 2023 by Malcolm Crowe 1 Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted April 27, 2023 Share Posted April 27, 2023 (edited) Also, have these projected lines been set as "Construction" lines? Malcolm Edited April 28, 2023 by Malcolm Crowe Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted April 27, 2023 Share Posted April 27, 2023 Can you upload the sample file that shows this issue and we can take a closer look to see what the cause is beside what Malcolm mentioned? Quote Link to comment Share on other sites More sharing options...
cadimonium Posted April 28, 2023 Author Share Posted April 28, 2023 23 hours ago, Malcolm Crowe said: Within the sketch, check the corners where the various lines meet. They need to be "Connected", which is indicated by a white dot. If any of these aren't white, right-click on the connection and select "Connect". Malcolm It's strange because even after I select "connect", nothing changes. Quote Link to comment Share on other sites More sharing options...
cadimonium Posted April 28, 2023 Author Share Posted April 28, 2023 (edited) And when I try to create an extrude, I get this error message, and it crashes. Edited April 28, 2023 by cadimonium Quote Link to comment Share on other sites More sharing options...
Bertrand Kim Posted April 28, 2023 Share Posted April 28, 2023 (edited) Hi cadimonium, Can you upload the sample file(the sketch) here? Kim Edited April 28, 2023 by Bertrand Kim Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.