caxa What arrow type should I use?

[MB-Furniture]

Hello everyone,

 

What arrow type should I use on a dimension specifying the center of, for example, a hole. I currently use the Oblique "arrow".

Is there maybe a sheet which shows when to use what arrow type? I have tried looking for one, but I can't find one.

 

Greetings,

MB

[SSIMMONS]

Can you be more specific? I ask only because generally you would use a center mark which you would then dimension to. The center mark itself would tell the viewer it was the center of the hole.

 

- Spencer

[SSIMMONS]

Like this:

 

[Cary OConnor]

Also, are you asking about specific standards like ISO or ANSI callout standards? If so, we would point to specific standard documents if you let us know which one you are looking for.

[MB-Furniture]

On 11/20/2020 at 3:20 PM, SSIMMONS said:

Like this:

 

Thank you for your reply,

I don't use the center marks. The drawings I make are already filled with information, if I would add centermarks I thinks this will make the drawings to busy.

[MB-Furniture]

On 11/20/2020 at 5:18 PM, Cary OConnor said:

Also, are you asking about specific standards like ISO or ANSI callout standards? If so, we would point to specific standard documents if you let us know which one you are looking for.

Thank you for your reply,

I believe I'm looking for the standards. I use ANSI.