tlehnhaeuser Posted March 12 Share Posted March 12 When I convert and when to edit the 3D curve, there appears to be "new" edit points and lines? Is this new? If so, whats the advantage. T Quote Link to comment Share on other sites More sharing options...
IronKevin Posted March 13 Share Posted March 13 The "lines" are just new displays, the edit points are the same as 2023. Just a new look, no new functionality. Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted March 13 Share Posted March 13 Hi Tom, Those are specifically for converted splines to allow positional editing (without converting to hundreds of points). These allow you to edit that converted spline where as if it was converted to points, it would be more difficult. This works on bsplines in 2D profiles (edges). Bezier curves will convert to points and these editing points (on each segment - see below). Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted March 14 Author Share Posted March 14 Aha Ok thank you both Quote Link to comment Share on other sites More sharing options...
SSIMMONS Posted March 15 Share Posted March 15 Yeah, this is common in a lot of 3D modeling software. Example below: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.