CAXA - When bend lines, bend annotations, centre-lines and such, don't show up on the drawing sheet

[HDEAR]

After a couple of frustrating moments of having no bend lines and annotations show up on a CAXA drawing unfold and hearing from Malcolm as well about a problem regarding centre lines not showing up, there's a simple fix that some people may not know.

This is caused by the ICS model not being perfectly lined up in the scene. Even just .01 degrees out in one plane, once the unfold takes place the bend lines and annotations will not appear. Similarly as Malcolm related to me, even centre lines won't show up if the model is out of line in the scene.

So if you experience this problem, then check your scene for the part alignment and your unfold for the same. Setting front view definition also helps.

Harley