pgascho Posted July 21, 2023 Share Posted July 21, 2023 This is a piece of adapted equipment for fishing. I want to force the top of this blend to match the profile of the green part (50mm cylinder) while the bottom of the blend stays at 10mm. I'd appreciate any pointers on where to look for help Quote Link to comment Share on other sites More sharing options...
ASPEER Posted July 21, 2023 Share Posted July 21, 2023 This looks like a Two Points blend use case to me. Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted July 21, 2023 Share Posted July 21, 2023 Can you share the model so we can test a few options? Quote Link to comment Share on other sites More sharing options...
pgascho Posted July 21, 2023 Author Share Posted July 21, 2023 Model attached Fishing rod adaptation.ics Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted July 21, 2023 Share Posted July 21, 2023 Well...It seems to be a fairly complex result. I think you may need to create a surface, thicken it, then do a boolean subtract. The surface can take on different shapes depending on how you create it. Here is a strait Ruled type surface result. A Mesh Surface would give more curvature that you define. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.