HDEAR Posted April 9, 2023 Share Posted April 9, 2023 (edited) Hi all, Following on from my previous post where I had a problem with 3 point positioning of sketch. Refer attached video. I managed to get a 3 point sketch position by drawing a line in the Rib loft path 1, and using that point to do the positioning. After I had completed my 90 degree and 270 degree sketches, I made the line that I had drawn in Rib loft 1 into construction. Then when I tried to carry out a surface loft, I could not get it to work. It looked ready to work at point 3, but failed miserably after that. I've tried various ways to get it to work but to no avail. Harley Flex hose surface loft failure.mp4 Flexible hose HD exercise.ics Edited April 9, 2023 by HDEAR Quote Link to comment Share on other sites More sharing options...
IronKevin Posted April 9, 2023 Share Posted April 9, 2023 Investigating. Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted April 9, 2023 Share Posted April 9, 2023 Hi Harley, The problem is with the direction of the "Arrow" after selecting the 4th arc. See the attached video. Malcolm IRONCAD - Surface Loft - Note Direction of Arrows.mp4 Quote Link to comment Share on other sites More sharing options...
HDEAR Posted April 9, 2023 Author Share Posted April 9, 2023 Thanks Malcolm, Those sneaky little arrows aye! Didn't think to even look for those. Much appreciated. Harley Quote Link to comment Share on other sites More sharing options...
HDEAR Posted April 9, 2023 Author Share Posted April 9, 2023 (edited) Finally! My Easter Holiday structured part training projects DONE! Thanks all Harley Edited April 9, 2023 by HDEAR 3 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.