Making Outside Cutted Cylinder item

[Bertrand Kim]

Hi everyone.

 

 

note.

For me, it is more friendly than Cut Spin bcuz in the machinery industry, I basicaly think how I make a shaft with a lathe.

And it was akward too making shaft stacking up one by one by using Cylinder for me

I've watched this item in the webinar, but there was not in my starter catalog.

https://ironcad.academy/tutorial/ironcad-mechanical-webinar

 

I have no idea why this isn't in start catalog

 

Thanks

Edited June 10, 2022 by Bertrand Kim

[Cary OConnor]

It is a useful method. I think both the Cut Spin and the Outside Cut are valid depending on your needs. It is something we can look at adding. 

Cary

[Bertrand Kim]

On 6/10/2022 at 10:42 PM, Cary OConnor said:

It is a useful method. I think both the Cut Spin and the Outside Cut are valid depending on your needs. It is something we can look at adding. 

Cary

Thanks Cary

Kim

[Jonas@Solidmakarna]

As a reseller in Sweden, we have made a customized version of the Starter catalog. It should be the one you see in that webinar too. If you have IronCAD DCS 2022 with PU1 installed, you can download this catalog from here: StarterSwe.icc

[Bertrand Kim]

44 minutes ago, Jonas@Solidmakarna said:

As a reseller in Sweden, we have made a customized version of the Starter catalog. It should be the one you see in that webinar too. If you have IronCAD DCS 2022 with PU1 installed, you can download this catalog from here: StarterSwe.icc

Hi, Jonas

Thanks for sharing

It will be useful

Kim