Tolerance of metric hole of IPROHoles issue

[Bertrand Kim]

Hello

I think "0" is missing while calculating

Some holes with tolerance

 

3H6 should be 3.008 not 3.080, 10H10 should be 10.07 not 10.7

 

 

Thanks for reading

Edited May 26, 2022 by Bertrand

[maurizio@fronema]

Hi Betrand,

thanks for the report.

Using the application IPROLibraryDataMgr.exe, you can set/edit the required values for tollerances:

Have a nice day

M

[Bertrand Kim]

23 minutes ago, maurizio@fronema said:

Hi Betrand,

thanks for the report.

Using the application IPROLibraryDataMgr.exe, you can set/edit the required values for tollerances:

Have a nice day

M

It is hard to change data one by one

 

1. Is there a way to open the table in exel?

 

2. How can I share in company after change the data? I want to know local directory of the table file.

 

ty

[maurizio@fronema]

Hi Bertrand,

here is the correct file.

These files are ASCII files, so you can edit them using Notepad or Notepad++.

This file has to be copied in the folder ..\Norme\Holes\

 

I hope this make sense to you

M

Diameters.dat

[Bertrand Kim]

7 minutes ago, maurizio@fronema said:

Hi Bertrand,

here is the correct file.

These files are ASCII files, so you can edit them using Notepad or Notepad++.

This file has to be copied in the folder ..\Norme\Holes\

 

I hope this make sense to you

M

Diameters.dat 3.32 kB · 0 downloads

I got it, I will try it tomorrow

 

thank you so much

 

Have a nice day