RCERVA

Thanks for the answers. Will try it tonight

Hi. Hope you all well. I need to roll square tubing for a client. Is their a way to make the drawing in Ironcad to show client the final product

Hi. Thanks. Did new 1 with only 1 ring yesterday and it worked.

Hi. Hope you all well. I need to transform a helix to flat metal part to send to cnc laser to cut strips to be welded together. But can't seem to be done. Can someone please assist to give me some idea of how I can do this. Thanks Josef mixer.ics

Thanks. Is there a way to seperate a mitred panel into seperate pieces.

Hi. Hope you well. I've made a electrical panel with Ironcad and using the mitre option. When I send it to my laser cutter in unfold format all good. But we want to split the tp and bottom section from the centre part. Does not work so good. So I've made new scene with centre piece and seperate parts for the top and bottom pieces. When I put all together the front s not mitred as we want it. Is there any way that when we put centre and top or bottom piece together the software can mitre the bits needed as per mitre command. 600x400x300 panel.ics

Thanks for your input. Will go through all tonight if power and internet available. Sitting in west africa where network very bad. Took me about 20min to watch your 5min video.

Hi. Tried it but can't seem to mitre only top 40 and 20mm folds. Wash bin side.ics

Thanks. I'll try it to see if it works.

Hi. Basically the 1st will be the 1 side with bottom. The 2nd will be the other long side. Then the 2 small sides will be added. I've done it with the mitre tool so if you hide some portions and have bend notches you get weird results. Doing laser welding so butt or seam does not matter. Just need to get the parts spilt into 4 parts retaining the mitre.

Hi. Basically the 1st will be the 1 side with bottom. The 2nd will be the other long side. Then the 2 small sides will be added. I've done it with the mitre tool so if you hide some portions and have bend notches you get weird results.

Hi. Can someone please assist. I've created a sheet metal bin and unfold the bin. It is to big for 1 sheet so I want to split up the unfolded part into smaller pieces for my cnc laser. Any ideas how this can be done. Westfalia wash bins.ics