tlehnhaeuser Posted August 9, 2010 Share Posted August 9, 2010 If you double click on 3D Curves this will bring you directly into edit mode. Quote Link to comment Share on other sites More sharing options...
cborer Posted August 10, 2010 Share Posted August 10, 2010 Tom! Welcome to Iron CAD Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted August 10, 2010 Author Share Posted August 10, 2010 You never know, never know, never know, did I say never know? Quote Link to comment Share on other sites More sharing options...
IronKevin Posted August 10, 2010 Share Posted August 10, 2010 Any tips are good tips, beginners read these too! Quote Link to comment Share on other sites More sharing options...
dhovatter Posted August 11, 2010 Share Posted August 11, 2010 IC Guys Why not start a thread called "Did You Know" where as often as each day IC guys would post a little thing about some commands or procedures that would help. Even the other Old time users could add their wisdom. The "IC Help Command" is sort of an joke in IC, not enough real how to information and on some things totaly non existent. It could even be referenced to in later threads. Or you could totaly revise the help command to have real information. Dallas Quote Link to comment Share on other sites More sharing options...
cborer Posted August 13, 2010 Share Posted August 13, 2010 (edited) Yes I agree The Help menue did not often help me. Could be advanced. So thanks again to Tom! ...I was just kidding. Edited August 13, 2010 by cborer Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.