Christian Skytte Posted August 14, 2006 Share Posted August 14, 2006 Closed Corner-option NOT working (I think??) I would really like to make a Closed Corner to this sheetmetal profile but IC will not accept it! If the closed corner is applied to a part where the added material is going outward it works just fine: But if (as you can see on this sketch) the added material is going the opposite direction, inward, the closed corner option fails! Here you can see that the setup for the closed corner option should be okay: Of course I'd like a (bloody) workaround - but if ANYBODY could tell me how to make this work the way it was meant to be it would be preferable!!!! c_skytte Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted August 14, 2006 Share Posted August 14, 2006 Can you send the file and highlight the area where you want the Closed Corner? I'm not sure I understand from your description. Cary Quote Link to comment Share on other sites More sharing options...
Christian Skytte Posted August 15, 2006 Author Share Posted August 15, 2006 Okay... On This file 8806020.ics I need a closed corner option ! What I do NOT need is here shown (with green circles) Hope this info is good enough!? c_skytte Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted August 15, 2006 Share Posted August 15, 2006 Here are the steps: 1. Select the Bend. 2. Move the Bend End (by pulling handles) so that it ends at the Angled Stock. 3. Switch the Bend to Relief Handles. 4. Snap to Point for Corner and select the Outside Stock. 5. Pull the Relief handle to Snap to the outside stock to eliminate the offset. 6. Reverse the Start end if needed. Cary Attached is an AVI file. ClosedCorner.zip Quote Link to comment Share on other sites More sharing options...
Christian Skytte Posted August 16, 2006 Author Share Posted August 16, 2006 NICE! ...Tanx a lot! c_skytte Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.