David Thomas Posted April 28, 2006 Share Posted April 28, 2006 Has anybody got any bright ideas as how to sweep this section around the guide curve. It will not do it correctly , I know the guide curve is not as clean as it could be but it was derived from a 3d edge. I can't seem to build a new guide curve on top of this one or the 3d edge as I pick the first point and then subsequent points just snap back to the first. This seems to be a bug. Lofting between the two end profiles with a guide curve fails completely. SootyandSweep.ics Quote Link to comment Share on other sites More sharing options...
cborer Posted April 28, 2006 Share Posted April 28, 2006 I tried in in 2 ways: 1. sweep along 3d curve from surface = failed (Nr2) Bug! 2. Create a new sweep from the shape creation set along 3d curve, project Otlines, sweep = seems OK (Nr3) Hope that helps Carlo SootyandSweep2.ics SootyandSweep3.ics Quote Link to comment Share on other sites More sharing options...
David Thomas Posted April 28, 2006 Author Share Posted April 28, 2006 aahhhh , parasolid , makes all the difference. acis will just not cut it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.