cborer Posted February 9, 2006 Share Posted February 9, 2006 Switch between Parasolid and Acis Kernel Acis will create a needless cut! Acis needs an Update! Carlo Acis_versus_Parasolid.ics Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted February 9, 2006 Share Posted February 9, 2006 Are you talking about the start/end edge? I think this is a limitation to ACIS. It cannot close a sweep shape onto itself (Create a sweep cylinder that ends at the start face and you can see the issue). It will always create that edge, where as Parasolid can support it. We can look to see if they have options for this but I think I remember this as a limitation. Cary Quote Link to comment Share on other sites More sharing options...
cborer Posted February 10, 2006 Author Share Posted February 10, 2006 (edited) Hi Cary Yes please this would be great. In fact the shape is a thicken shape. But I got many problems cause of this limitation. It was counted in my list of wishes as: "delete not used edges" cause it looks like an edge. I thought the thicken shapes are not sweep shapes, so I learned about that today. To me it is important cause I want to unfold the faces later and this is a cut trough the face. And even one more: I create my shapes by "Thicken Face" and will "Thicken Face" the result again! (this is unfoldable) See my new work Many thanks Carlo Edited February 10, 2006 by cborer Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted February 10, 2006 Share Posted February 10, 2006 Nice stuff Carlo! your work is great an right up my alley. How much for this one? Are you commissed? or do you create and then sell? tom Quote Link to comment Share on other sites More sharing options...
cborer Posted February 10, 2006 Author Share Posted February 10, 2006 Thanks Tom I work mostly on stock but I do commissions also. This one goes on an exhibition in March and will stand in front of a church. Carlo Quote Link to comment Share on other sites More sharing options...
Guest Herr Kesterke Posted February 11, 2006 Share Posted February 11, 2006 Super teil !!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.