Guest svangeldern Posted February 23, 2002 Share Posted February 23, 2002 Hey, I have groove cut into a cylinder. The groove starts at 12 o'clock and moving in a clockwise direction ends at 9 o'clock (270 degrees, see attached). I can't get IC to display a 270 degree dimension, it alway displays a 90 degree dimension. Any ideas? Steve angle.icd Quote Link to comment Share on other sites More sharing options...
Chris Lohman Posted February 26, 2002 Share Posted February 26, 2002 IronCAD doesn't have the ability to switch from acute to obtuse dimensions like this. I have placed the enhancement request. Quote Link to comment Share on other sites More sharing options...
Alex Khenkin Posted February 26, 2002 Share Posted February 26, 2002 Steve, There is one thing you can do meanwhile: go into dimension properties, text, check "replace measurement..." box, then type "270°" in "postfix" box, then OK. It will display "270°". I used this trick on many different occasions. Alex. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.