Guest Werner Schappacher Posted October 13, 2005 Share Posted October 13, 2005 I just tried to remove IronPRO (Test installation) The deinstallation worked, but i can't start Ironcad again. Each time i try to start ironcad, the windows installer starts! I have to go to the taskmanager and kill that process. Heeeeeeelp! Werner Quote Link to comment Share on other sites More sharing options...
Guest Werner Schappacher Posted October 13, 2005 Share Posted October 13, 2005 I had to run a repair installation. Lost most of my settings. Wastet time. But IC runs again Werner Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted October 13, 2005 Share Posted October 13, 2005 Did you try to let the windows installer finish instead of killing that process? Cary Quote Link to comment Share on other sites More sharing options...
Guest pfarrer Posted October 14, 2005 Share Posted October 14, 2005 The deinstallation worked, but i can't start Ironcad again. Each time i try to start ironcad, the windows installer starts! Same here! It really screwed up my installation. I ended up reloading IronCad. Quote Link to comment Share on other sites More sharing options...
Jonas@Solidmakarna Posted October 14, 2005 Share Posted October 14, 2005 This is quite common after IronPRO has been uninstalled. I think it's some register setting that gets messed up. If the Windows installer appears when you start IronCAD, close it with the Taskmanager. Then put in your IronCAD 8.0 CD. Most often the installer will find the file it's looking for (Ironcad8.msi) and run the repair that it must make. If not, you'll have to look for it by clicking on the browse button. It's placed here: "CD-drive":\Installs\IRONCAD\Ironcad8.msi Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.