Chris Lohman Posted December 5, 2001 Share Posted December 5, 2001 I just ran into this situation today. A user was running NT 4.0 and the boot screen reported he was at Service Pack 4. He attempted to install IronCAD and the install just hung at 0% progress. It turned out that this system was at NT 4 at one time but had been back-rev'd to a previous service pack level. The level they were at is unknown. After they installed Service Pack 5 for NT 4.0 then the IronCAD install would progress. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.