SSIMMONS Posted February 28 Share Posted February 28 Is there a way to make default behavior when dropping an IC fastener to NOT display thread callouts in ICD. Some of my co-workers computers are fairly old and we have hundreds of fasteners typically so this slows down peoples ICD loading significantly. Thanks. -Spencer Quote Link to comment Share on other sites More sharing options...
IronKevin Posted February 28 Share Posted February 28 It’s an option in Sheet Setup in the ICD. 1 Quote Link to comment Share on other sites More sharing options...
SSIMMONS Posted February 28 Author Share Posted February 28 2 minutes ago, IronKevin said: It’s an option in Sheet Setup in the ICD. Ah, thanks Kevin. I knew there was a way, but couldn't remember. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.