MarWos Posted May 20, 2021 Share Posted May 20, 2021 Can I do intermittent view on two views at the same time? I would like the interrupt to be the same on both views. Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted May 20, 2021 Share Posted May 20, 2021 One way is to create a Auxiliary view of the broken view. That will maintain the broken region on this new view generated. Cary Quote Link to comment Share on other sites More sharing options...
MarWos Posted May 21, 2021 Author Share Posted May 21, 2021 One way ? Are they other ? What ? Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted May 21, 2021 Share Posted May 21, 2021 That is currently the only way at the moment. Either Auxiliary or Section view of a broken view. There is a ER requested for a projection view of a broken view or multiple view support. Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted May 23, 2021 Share Posted May 23, 2021 For your interest, in the "Tips and Tricks" forum (link below) I've added a post demonstrating how to create aligned break lines between Broken Views within CAXA. You might be able to apply the 2nd method to ICD also. Malcolm Quote Link to comment Share on other sites More sharing options...
MarWos Posted May 25, 2021 Author Share Posted May 25, 2021 The first way does not work for me as you can see on video below  Video 2.avi Quote Link to comment Share on other sites More sharing options...
MarWos Posted May 25, 2021 Author Share Posted May 25, 2021 How to remove intermittent view from view without using UNDO ARROW? Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted May 25, 2021 Share Posted May 25, 2021 Attached is an old 2015 video demonstrating how to edit breaks and to restore to previous unbroken state. Malcolm. IRONCAD DRAFT 2015 - Broken View - Improvement.mp4 Quote Link to comment Share on other sites More sharing options...
Malcolm Crowe Posted May 25, 2021 Share Posted May 25, 2021 (edited) 2 hours ago, MarWos said: The first way does not work for me as you can see on video below Whenever you start a command in CAXA, take note of the options displayed in the bottom left corner of the screen. In the case of the "Projection View" command, option 2 gives you the option to either "Sync" or "Not Sync" Broken Views. If you select "Sync Broken View" it should then work for you. See the attached image. Malcolm Edited May 25, 2021 by Malcolm Crowe Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.