Robert Andersson Posted February 8, 2003 Share Posted February 8, 2003 If you use a section tool in the scene to show a section of a part/ assy and you export that to a .TIF with relistic+antialiasing on, you end up with a .TIF that shows the part/assy NOT sectioned. Solution is to rightmouse the section tool an switch to Precise mode. Then IronCAD will produce a clean section in the exported image. Robert Andersson Quote Link to comment Share on other sites More sharing options...
Per-Arne Almeflo Posted February 10, 2003 Share Posted February 10, 2003 Yes, and you cannot get the smart dimensions to work between sectioned and unsectioned parts unless you are in precision mode. But, I have also run into some trouble when leaving the section tool supressed in an assembly. I have the pneumatic cylinders that I used the "Section Part/Assembly" tool to put a smart dimension between the piston and the inside bottom of the cylinder housing. When done, I left it in the supressed mode. Later when I imported these cylinders as linked parts into an assembly I found that it was not possible to save and exit that assembly anymore. When I deleted the Section Tool from the cylinder all was OK again, and it was possible to save the assembly. Quote Link to comment Share on other sites More sharing options...
Guest Wim Posted February 10, 2003 Share Posted February 10, 2003 i have the same trouble with the sectiontool, not able to save many times. its a bug Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.