Problems in modeling - model mania

[dleczynski]

model 1

 

I try to do this simple mode, but in a parametric way. Often in such models curves arise in one sketch. It is easier to determine the relationship / bond between the curves.

 

If you do offset curves and trim. You can add a dimension offset.

Extrude also doing the problem, does not preserve the dimensions. Do you have any idea? So it looks like the inventor:

 

 

Selecting outline works only in the structural parts, but does not select the line of cut as INV:

 

I want to see how to build the model.

 

if you want to add dimension to the offset, you need to hold down the SHIFT key and then add a lot of bonds: tangent, concentric, conform to gemetria worked.

Edited April 19, 2015 by dleczynski

[dleczynski]

model 2

 

in this model is the problem: you have to share the curves and give another relations that the model was consistent. If you do not see the outline of the extrude and you need to edit the profile again. You can not change the auxiliary curves construction or disconnected because the whole outline is skipped, so remove it. This method is not practical because you lose your connection.

 

 

At the 10:05 minute movie bug

Edited April 19, 2015 by dleczynski