rjensen556642

I can`t change the first and second bend stok on this part. I would like to set the value to 0. 2810055_B_reskinne_1.ics

Hello wgrein, Thank you for the Part. I thin that the part 50 is the most easy way to model the part. Behapes it will be posible to draw the unfolded part first and then make an skets and use the skets to make the bend in IC 9......?? I hope i can help you som other time.

Hello Mmccall, i can save the sheetmetal part in IronCad version 8 because i have an computer whitout the upgrade. I do it in the end of the day.

Hej Christian, det er rigtigt. Det er egentligt mærkeligt at man ikke kan bukke over en skets i IronCad. Det kan man i næsten alle andre progarmmer. Jeg her selv brugt Inventor i 5 år inden jeg hoppe på IronCad i forbindelse med et jobskifte.

Here is the sheetmetalpart i was describing for you. If any off you have an better way to model this part i would be happy to here from one off you. It is very important, that the part i square when it is unfolded. Firkantplade3.ics

How can i create an sheetmetalpart whit an crossbend 3 deg.? It have to be square whit strait sides when it is unfolded. Can IronCad bend over an skets?