Rich Migliaccio

Hey Tom, Are you now able to see the decals in the PDF? If so, what PDF reader are you using? I'm using Adobe Reader X V10.1.15 and don't see any decals. -Rich

Hatch accuracy based on part faceting was already unselected. However, turning it on with increased smoothness did the trick. Thank you Kevin

In IronCad drawing, when hatching parts with rounded perimeters, the hatch lines do not extend to the part edge if precise mode if selected. Is there anyway to correct this? See attached figure. Thanks, Rich

Thank you Dprodanic and IronKevin Looks like my biggest hurdle is getting Dirextx to run. Right now I'm running OpenGL as anything else hangs. I'll also make sure to update to PU1.

Tom, I used a program called AccuTrans3D to import an ascii file with XYZ point cloud data and convert it to a 3d studio (3ds) file. The problem I run into is that Ironcad runs extremely slow using anything above 100 x 90 pixels while the AccuTrans3D program shows no slowing down at all. I have every render option disabled, but no luck with it. I attached the xyz cloud point data and 3ds files for a 344 x 300 pixel case and a rendering of the 50 x 50 pixel case. -Rich Stone_wall_test344x300.3ds Stone_wall_test344x300.txt Stone_wall_test_50x50.bmp