Welcome Guest ( Log In)

 
Reply to this topicStart new topicStart Poll

Outline · [ Standard ] · Linear+

> Working out block size/angles into rect. holes

HDEAR
post Aug 7 2017, 02:23 AM
Post #1


Polygon
***

Group: Community Members
Posts: 107
Joined: 5-July 14
From: Auckland, New Zealand
Member No.: 63,873



I have asked my 'space cadet' son to come up with a formula to work this out mathematically, but I was wondering how I can draw the following in 2D in a scene and then extrude.

I need to fit blocks of a known thickness across two opposing corners of a rectangular hole.

The rules are that all points W, X, Y and Z of the red block must touch the edges of the rectangular hole.

I have three known quantities;

W ( width of hole e.g. 700mm )
H ( height of hole e.g. 356.25mm )
T ( thickness of material 55mm )

How do I go about drawing this in 2D sketch in the Scene? Obviously I need to restrain points and offset the block's side L ( which I don't know what length it is ) but I don't know how to go about this.

Any ideas, videos ?

Thanks

This post has been edited by HDEAR: Aug 7 2017, 02:24 AM

Attached thumbnail(s)
Attached Image
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicTopic OptionsStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
 

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 19th November 2017 - 08:48 AM