Mike Twining Posted September 12, 2008 Share Posted September 12, 2008 I'm having an early senior moment here. I could have sworn that there was an easy way to reverse the direction of a guide curve (for a sweep), but for the life of me I can't figure out how (I am talking about the direction of the 2d guild curve line, NOT the sweep extrude direction). Was I just making up the thought that this is possible? A colleague has created a fully constrained guide curve where the end point (NOT the start point) is located at 0,0 (center of the x-section), and therefore the sweep does not compute properly. I told him, "Right-click the curve, select outline, right-click the outline, select 'reverse direction', done!" as I rattled it off in my mind. He then told me I was crazy....am I? Quote Link to comment Share on other sites More sharing options...
IronKevin Posted September 12, 2008 Share Posted September 12, 2008 There is a "Flip Sweep Direction" on the Sweep Shape right-click menu and you can Reverse Direction on a 3D Curve but I'm not aware of a reverse direction for the 2D Curves. Quote Link to comment Share on other sites More sharing options...
Mike Twining Posted September 12, 2008 Author Share Posted September 12, 2008 ...So I am crazy... that is too bad. How about an ER then. Quote Link to comment Share on other sites More sharing options...
Guest svangeldern Posted September 13, 2008 Share Posted September 13, 2008 Mike, Crazy like a fox... Steve Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.