tlehnhaeuser Posted October 24, 2006 Share Posted October 24, 2006 OK, Trying to get a better grasp on DV's. I am trying to make a PEM nut but for some reason it will not allow me to make additional DV's. What am I doing wrong? thanks Tom PEM_DV.ics Quote Link to comment Share on other sites More sharing options...
Robert Andersson Posted October 24, 2006 Share Posted October 24, 2006 (edited) -You have to apply a part level parameter from the parameter table. Then you can link all other parameters to that main parameter. This main parameter will show in the Design Variation Table. -If you want a assembly level variant, you have to do the same at that level. PEM_DV_2.ics Edited October 24, 2006 by Robert Andersson Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted October 24, 2006 Author Share Posted October 24, 2006 Thanks Robert, That did the trick. Just needed a little nudge tom Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.