tlehnhaeuser Posted August 17, 2005 Share Posted August 17, 2005 I am trying to create a side surface to this bag but I came seem to figure out how to do it. Its not a flat surface otherwise RULED would work, its "domed". Any ideas anyone? Thanks Tom Surface1.ics Quote Link to comment Share on other sites More sharing options...
Guest IronKevin Posted August 17, 2005 Share Posted August 17, 2005 I had to split the curves and make three surfaces, an Edge in the middle and Patch surfaces on the ends. IK Surface1.ics Quote Link to comment Share on other sites More sharing options...
Guest bkline Posted August 17, 2005 Share Posted August 17, 2005 Use Acis kernal. Split perimeter curves to create patches. Make sure all ends join. Note: this does NOT create a 0 surface continunity. Bret Surface1.ics Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted August 17, 2005 Author Share Posted August 17, 2005 Thanks Guys, that helped tremendously tom Quote Link to comment Share on other sites More sharing options...
B. Ludin Posted August 17, 2005 Share Posted August 17, 2005 Here's a single-patch UV-mesh version. Surface1.ics Cheers, Beat Quote Link to comment Share on other sites More sharing options...
Guest IronKevin Posted August 17, 2005 Share Posted August 17, 2005 Very nice. IK Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.