Guest rbame Posted March 30, 2005 Share Posted March 30, 2005 I am trying to model this remote using surfaces. Any recommendations? I have the three 3D sketches it could be built on.. I think.. forum.ics Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted April 1, 2005 Share Posted April 1, 2005 Sorry Rodney, I don;t have an answer for yo on this one. I will keep trying though. I also have one . See attached. Tom Surface.ics Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted April 21, 2005 Share Posted April 21, 2005 Hi Tom, Yours can be done fairly easy in 8.0 by using the Trim Curve and the Edge Surface. You basically will trim the curves into four patch regions. Then use the edge surface (with tangency) to close the surface. Image Below... Cary Quote Link to comment Share on other sites More sharing options...
mmccall Posted April 22, 2005 Share Posted April 22, 2005 HA!!.. and 8.0 will be released ... WHEN??? Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted April 22, 2005 Share Posted April 22, 2005 Thanks Cary, I look forward to 8.0 in June! Thanks TOm Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted April 22, 2005 Share Posted April 22, 2005 8.0 will be shipped out in June (unless some major issue comes up). Keep an eye out for the beta program announcment today or Moday. Cary Quote Link to comment Share on other sites More sharing options...
cborer Posted April 23, 2005 Share Posted April 23, 2005 Cary These are real good news! Is there already a list with the features around? Thanks Carlo Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted April 23, 2005 Share Posted April 23, 2005 Carlo, In order to see the list, you probably have to sign up as a beta testor. http://www.ironcad.com/support/community/i...?showtopic=2571 Tom Quote Link to comment Share on other sites More sharing options...
Guest rbame Posted April 27, 2005 Share Posted April 27, 2005 The answer is to use Rhino.. The surfacing is light years ahead of IronCAD. However, the combination of Rhino and IronCAD makes for the most powerful modeling cabilities I have seen.. Both are easy to use and great at core technologies.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.