Guest Kaspars Posted March 14, 2023 Share Posted March 14, 2023 Here are two images of one file. First one is opened with step file viewer, the other imported into a new scene in IronCAD. What's the problem? Step viewer: IronCAD 2022 after installing the last hotfix: What did the hotfix do to the file, while exporting? Also when using "Edit Cross-section" - I can draw lines only on one axis, e.g. horizontally. Has anyone come across these glitches? Quote Link to comment Share on other sites More sharing options...
IronKevin Posted March 14, 2023 Share Posted March 14, 2023 2022 or 2023? Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted March 14, 2023 Share Posted March 14, 2023 Change your default kernel to ACIS and import again. This is a known issue we sent to the Import partner for Parasolid and Step. Acis seems to handle the cases. Quote Link to comment Share on other sites More sharing options...
Guest Kaspars Posted March 14, 2023 Share Posted March 14, 2023 Cary OConnor - thanks, did that, the layout changed a bit, but the problem is not solved. The result can be seen below: Quote Link to comment Share on other sites More sharing options...
Guest Kaspars Posted March 14, 2023 Share Posted March 14, 2023 Thanks, OConnor, did that, the layout changed a bit, but the problem persists. Quote Link to comment Share on other sites More sharing options...
Guest Kaspars Posted March 14, 2023 Share Posted March 14, 2023 IC support suggested to change decimal separator to comma (it was set to point) and it solved all problems. ACIS setting did not help. Quote Link to comment Share on other sites More sharing options...
Bookels Posted March 23, 2023 Share Posted March 23, 2023 On 3/14/2023 at 7:24 PM, Guest Kaspars said: Here are two images of one file. First one is opened with step file viewer, the other imported into a new scene in IronCAD. What's the problem? Step viewer: IronCAD 2022 after installing the last hotfix: What did the hotfix do to the file, while exporting? Also when using "Edit Cross-section" - I can draw lines only on one axis, e.g. horizontally. Has anyone come across these glitches? Same here after installing hotfix 2023. Quote Link to comment Share on other sites More sharing options...
dleczynski Posted March 23, 2023 Share Posted March 23, 2023 send model priv Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.