jolizon590016 Posted January 7, 2022 Share Posted January 7, 2022 (edited) Hi, I been trying to get this done following this https://www.ironcad.com/blog/dynamic-parametric-cad-design/ so far it didn't go well I always orient the extrude length on Z axis so on the bom all length will appear in the height column. Even trying to use the same naming convention doesn't allow me as follows below This being done in IC2021. Appreciate any resolution or work around. The blade is in the position as in certain case it has to be trimmed with the damper height requirement. Blade spindle is set at 80mm center to center. Regards Damper1A.ics Edited January 7, 2022 by jolizon590016 Quote Link to comment Share on other sites More sharing options...
jolizon590016 Posted January 11, 2022 Author Share Posted January 11, 2022 Got it to work this way with just single blade. I can then add the blades via the tri-ball linear pattern downwards. The final blade is a copy that needs to be trimmed according to the overall height required. regards Damper1A.ics Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.