Tray part

1)Start with stock
2)Make vert bend
3)Add next bend in and set length to zero
4)Add stock to that bend
5)Make next bend up - set bend length as required
6)Make horiz bend out and set length to zero
7)Add stock
8)Make bend relief 'Closed/Top/4'
9) Edit add stock, set up mitre and restrain
10)Make bend relief 'Closed/Top/4'
11)Make top bend reife 'Close/Top/-4'
12)Edit add stock, set up mitre and restrain
13)"Mirror Feature" - bends and add stock ( do not use tribal mirror! )

End parts

A)Copy tray
B)Delete mirror and stock and 1st bend and just leave top section
C)Position bend using Triball
D)Change bend reliefs to match ( to -2 )
E)Adjust length ( inside face of tray minus 2mm )
F)Add stock and set length.
G) Mirror end