jolizon590016 Posted June 27, 2017 Share Posted June 27, 2017 I am trying to create an insert so to mask the sharp corners on sheet metal tank. It is something like an icing tip, instead of round to flat, it is rectangular to flat. I have joined the sheet metal to create a connected surface with blend of 1.5 to 8.0 as shown on the middle image. Is there a quick way for a press bend on this one, appreciate your help on this one. Twin_Spat_Tank_R2.1_T1.2_cut_out.ics Quote Link to comment Share on other sites More sharing options...
IronKevin Posted June 27, 2017 Share Posted June 27, 2017 Is this about right? Press_bend.ics Quote Link to comment Share on other sites More sharing options...
jolizon590016 Posted June 27, 2017 Author Share Posted June 27, 2017 Perfect Kevin. I will see if I can still increase the radius on the bottom. Thanks for the hand on this. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.