rsaucier Posted June 7, 2017 Share Posted June 7, 2017 Hoping someone a lot smarter than me might be able to help with this. Attached is a rough image of what I need to accomplish. Basically connecting the two points like a cam might be. Any ideas? Many thanks in advance. RJ Quote Link to comment Share on other sites More sharing options...
tlehnhaeuser Posted June 8, 2017 Share Posted June 8, 2017 This help you RJ? Tom Quote Link to comment Share on other sites More sharing options...
Robert Andersson Posted June 8, 2017 Share Posted June 8, 2017 Maybe a Formula curve can do the job. Quote Link to comment Share on other sites More sharing options...
rsaucier Posted June 8, 2017 Author Share Posted June 8, 2017 This help you RJ? Tom 45405[/snapback] Tom, That would be OK except that I need it to have a smooth transition so as it goes around the radius, it smoothly gets further from the center point. It is not a consistent radius. But that was pretty good thinking. I had not thought about that. thanks for the input. Quote Link to comment Share on other sites More sharing options...
rsaucier Posted June 8, 2017 Author Share Posted June 8, 2017 Maybe a Formula curve can do the job. 45406[/snapback] Robert, That is what I thought as well, but did not know which one to use or what parameters to input. How did you get the one shown in the picture. I entered the values as shown in the snapshot, but got a way different result. Also, I did not see the Archimedes Spiral-RA on my list. Could that be part of it? I am very appreciative of your help. Thanks RJ Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.