Jump to content

SVAN GELDERN

Community Members
  • Posts

    80
  • Joined

  • Last visited

1 Follower

Recent Profile Visitors

1,025 profile views

SVAN GELDERN's Achievements

Cylinder

Cylinder (3/9)

6

Reputation

  1. IC Dudes, The hotfix worked nicely for the prints I had to generate today. Exports were clean, crisp and included both finish and weld symbols. Thanks.
  2. The solution to this issue should be included in a "HotFix". 2021 is a loooong way away.
  3. Is there a tutorial on the Shrink Wrap tool? The tool has produced favorable results when used on models I have downloaded from various manufactures . Although the default settings always result in a smaller file size, I do not always get all of the model features I had hoped for. Select Parts to Keep. (understood) Select to Discard. (understood) Similar parts checkbox? What is a similar part? Convert Block to Part? Advantages/Disadvantages Select Faces to Keep (understood). Equal Radius? Concentric? Part Size to Discard? Percentage? How is the percentage determined? Hole Patching? What does hole patching do? All? None? Range? Simplification Options? Use Percentage? Remove Invisible Parts? Visibility? Combine into One Part? Advantages/Disadvantages Link to original File? Not selectable? Create shell? Keep Saved File Open (understood)) Thanks, Steve
  4. I'm guessing you may have different configurations set/selected in the two files. Configurations can be set to save part positions. Just a guess. Steve
  5. My submission... MASS: 2.3322 g VOLUME: 2200.2117 mm^3 SURFACE AREA: 4270.4392 mm^2 Steve VGM_INVUSION_002A.PDF vGm_Invusion_002A.ics
  6. jolizon590016, Looks good. Double check your density. The .ICS above uses 1.07 g/cm3 I think the challenge specified 1.06 g/cm3 Steve
  7. This was fun! My approach was to look at it like I actually had to build it. (2) custom joints and a single spar. Calculated Mass: 2.3744 g Calculated volume: 2198.5373 mm Steve vGm_Invusion_002.ics
  8. FYI... I could not select a part in the scene browser and F10 would bring up a pop-up menu, not the triball, after the hot fix. A reboot solved the issue. The triball is now as she should be. Steve
  9. Tried to create a hole table today....still unusable for the reasons outlined above (IC 64Bit Version Build Number:15558).
  10. Let's say I have a serpentine belt and there are 12 different pulleys involved...How do you add the "negative" shapes? The default catalog item only has 2. Thanks.
  11. http://www.stratasys.com/solutions/stratas...t-manufacturing
  12. I am seeing this in a particular scene. I will send the file to support.
  13. Cary, Thanks. Your post prompted me to delve a little deeper.... I had created my original 3d curve by highlighting edges on a model and then using "Extract 3d Curve". It appears that IC makes some sequence assumptions as to how the edges are to be connected. The starting point of the curve also appears to be random. These assumption not only show up in the animation profile but also in the XYZ data of an exported step file (Extract_Trace.png) displayed in a program supplied by a motion controller vendor. If I create a 3d curve by picking points along the desired edge, the animation profile and starting point reflect the desired results, as does the exported data (Pick_Trace.jpg). Extracting would be much easier and more more precise than picking points. Enhancement request: "Extract 3d Curve" retains pick sequence and start point. Steve
×
×
  • Create New...