msecco Posted October 27, 2016 Share Posted October 27, 2016 When I try to create a Formula Curve in a sketch, IC shows me 2 dialog boxes (images attached) and no curve preview in Formula Curve dialog. It is not possible to create curves too. I didn't find whre to configurate these values (Step Length and Tolerace) required. How to fix it? Quote Link to comment Share on other sites More sharing options...
Jonas@Solidmakarna Posted October 27, 2016 Share Posted October 27, 2016 Hi! You could either change the system decimal to a point (dot) or change the values to higher than 0 using . as a decimal. Then Preview to update. This was reported a while ago and got Incident ID#: 107478 Quote Link to comment Share on other sites More sharing options...
msecco Posted October 27, 2016 Author Share Posted October 27, 2016 Hi! You could either change the system decimal to a point (dot) or change the values to higher than 0 using . as a decimal. Then Preview to update. This was reported a while ago and got Incident ID#: 107478 44055[/snapback] Thank you, Jonas Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.