Jump to content

JHARNISH

Members
  • Posts

    5
  • Joined

  • Last visited

JHARNISH's Achievements

Block

Block (2/9)

0

Reputation

  1. I was wondering why you can’t specify the note height in a drawing using "in" or "mm"? Specifying the “pt” is just not an accepted standard or precise enough. If you are familiar with ANSI Y14.2 /5 drafting standards, you typically set your note height in inches/mm for Notes, Titles, etc. It seems we are being forced to abandon drafting standards. Does anyone else think this fundamental feature is worth having? What are people doing to set the Note height = 1/4" exactly?
  2. We are looking for a draftsman/designer with IronCAD experience to work full-time 40 hrs/week at out West Chester, PA office. We design and fabricate heat transfer equipment. We are currently designing a skid mounted unit with piping and equipment. This is a temporary project that will take approximately 3 months, but will consider hiring the right person permanently depending on successful project completion. If interested, send me a “Personal Message”. Thanks, Jim
×
×
  • Create New...