Spencer,
Thanks for the prompt response. Unfortunately, this software is very picky and will only accept .DSTV. It wont even accept, IGS, STP, DXF, nothing.
Hello everyone. I have a customer that has a bema line and is asking for beams in the model to converted to .DSTV format for their machine. I know IronCAD doe snot support this but wanted to see if anyone has ever come across this and found a solution. Any help would be greatly appreciated.
I have a customer that is inquiring about using curved screens. Is anyone using curved monitors and if so, and thoughts from your experience using them vs flat monitors?
Thank you everyone for your feedback. I am going to leave the poll open so feel free to add your vote if you have not already or any additional comments. Thanks again.
RJ
Malcolm,
If it is thin sheet metal, you can unfold the part and the results will be very close to what you need. It does not work on thicker plate though. You get one side that is correct and the other side is not. On thicker plate, maybe what I attached is an option. It is a few steps still but I think quicker than the steps you showed. Let me know what you think.
bandicam 2021-05-28 11-01-48-738.mp4