jolizon590016 Posted April 28, 2017 Share Posted April 28, 2017 I was working on updating both 3d model and drawing and added a view onn the drawing. Upon saving it got a notification that there was inconsistency with the view created. So I removed the view and saved. After working on some added sheets upon saving I got a notification on invalid parameter cannot save the file. I already created a save as but still happening. I don't know what is going on. Never had issues with my updated hardware since it was setup and running things daily without a hitch on other projects. Quote Link to comment Share on other sites More sharing options...
jolizon590016 Posted April 28, 2017 Author Share Posted April 28, 2017 I change this part from acis to parasolid and it seems to allow me to save it. Initialyy the one on the left had a section with dimensions to illustrate the profile, it working fine and it started the problem when I added the one from right later. Quote Link to comment Share on other sites More sharing options...
jolizon590016 Posted April 28, 2017 Author Share Posted April 28, 2017 (edited) Once I added the a reference line on the bottom right for holes, I get the error and: Failed to save the document: Cause: Unspecified error Removed the reference line and it save again. Edited April 28, 2017 by jolizon590016 Quote Link to comment Share on other sites More sharing options...
IronKevin Posted April 28, 2017 Share Posted April 28, 2017 Please send the files and video to support@ironcad.com and we will investigate. Quote Link to comment Share on other sites More sharing options...
Cary OConnor Posted April 28, 2017 Share Posted April 28, 2017 Reference Lines - Do you mean section lines? Is the section exactly at the center of the circular part? Quote Link to comment Share on other sites More sharing options...
jolizon590016 Posted April 28, 2017 Author Share Posted April 28, 2017 (edited) Hi Cary, when I use line from annotation to trace the holes for angle position or annotation dimension are placed on the section I can't save it anymore. Beforehand, it only contained the Part658 blade head nose with the section dimensions and never had any problem. I just added the Part658 Rear nose and it caused all of the problems. My apologies for the video, I don't want to ruin the file as my save as copies no longer can be opened. I already sent the ics and icd via wetransfer to support@ironcad.com. Thanks to the team for the attention on this. Regards. Edited April 28, 2017 by jolizon590016 Quote Link to comment Share on other sites More sharing options...
Guest TCHITANDA Posted April 28, 2017 Share Posted April 28, 2017 Hello Joseph, I can confirm that this incident has been logged (Incident ID#: 108456) The issue will be considered in the future to be resolved in a later version of the product. A further message will be sent if or when the state of the issue changes. If you have any additional information regarding this case or need immediate feedback, please quote the attached Ref Number in all correspondence. Tito Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.